Diamond disc 2-in-1 and miter

The 2-in-1 diamond disc combines cutting and grinding in a single disc, purpose-designed for chamfering tiles and ceramics at a 45-degree angle. Mitre work — bevelling the tile edge so two tiles meet seamlessly on an outside corner — is one of the most demanding techniques in professional tiling.

Cutting and grinding in one pass

Where you would normally need two separate discs — one to cut and one to bevel — the 2-in-1 disc handles both tasks. The top face cuts while the underside grinds the edge to the desired angle. This not only saves a disc change but also delivers a more consistent result because you work in the same set-up. The difference is visible in tight corners with no lips or unevenness.

Mitre work on the angle grinder

Most professionals use the 2-in-1 disc on an angle grinder fitted with a mitre guide. The guide holds the grinder at a constant angle to the tile, producing an even bevel along the entire length. Without a guide it is nearly impossible to maintain a consistent 45-degree angle, especially on longer tiles. Always invest in a quality guide alongside the disc — the combination is what makes the difference in your finished corners.

Crisp corners on outside edges

Good mitre work starts with a sharp disc and a stable guide. A worn or vibrating disc leaves an uneven bevel that is visible in the finished corner. Replace the disc on time and inspect the guide regularly to maintain quality throughout the job.

Professional mitre work stands out at visible outside corners in showers, kitchens and window sills. With the right 2-in-1 disc and a stable guide you produce corners that look sharp and high-end. Remember that good mitre work starts with a sharp disc and a stable guide — a worn or wobbly set-up leaves an uneven bevel that is visible in the finished result. Browse our mitre discs, order directly and benefit from fast shipping. Browse our mitre discs, order directly and benefit from fast shipping so your project keeps moving.